|
- Power Supply
Generates 5V, +/-12V,-25V(LCD VGA drive),-22V(LCD VGA supply) o/p from 220VAC.Digital on/off control for LCD VGA drive. Required VCCIO (3.3V) and VCCINT (2.5V) to support I/O standards are generated on board.
- LCD DISPLAY MODULE
A 4 row X 20 column LCD module to display graphic or text information
- LCD VGA DISPLAY
A 320 X 240 pixel LCD VGA display to display graphic or text information
- SIXTEEN SEGMENT LED DISPLAY
Eight, multiplexed, 16 Segment LED displays are provided. The user can use them to indicate the inputs applied and the outputs of a design. The 136 LEDs may be used individually or as a multiplexed alphanumeric display [Useful to monitor counter, shift register, combinatorial design outputs].
- LEDS
3 LEDs are present and can be used as above to indicate the inputs applied and the output of the design.
- BUZZER
Buzzer is present and can be used as above to indicate the inputs applied and the output of the design.
- SOLID STATE RELAY
This can switch a 220V, 16A AC low inductive loads. It is used to switch on/off the contactor described below and can be used for any other purpose.
- CONTACTOR
This 4 NO 1NC, 440 VAC, 5.5 kW contactor can be used to switch 3 phase/ single phase AC or DC loads such as air conditioners, pumps, motors, fans and other industrial/lab equipment.
- A TO D CONVERTOR
Choice of Analog Devices AD670 with 8-bit data , 10us conversion time and 0 to 5V analog input ,through a pot, or, an AD1674 device with 12 bit data , 10us conversion time and 16 Nos,+/- 12V, analog channels.
- DIP SWITCHES
An 8X2 matrix of DIP Switches are provided for digital inputs to the FPGA.
- KEYBOARD
Sixteen keys in 8 X 2 matrix configuration are provided and can be used as a multiplexed keyboard or as individual digital inputs.
- JTAG DOWNLOAD CABLE
Has a 25 pins D Type connector on both sides. It Connects the 25 pin D connector on the trainer to the PC's parallel port and is used for downloading designs from the PC to the FPGA via its JTAG port
- SERIAL CABLE
Has a 9 pins D Type connector on both sides. It connects the 9 pins D connector on the trainer to the PC's serial port and is used for transmitting and receiving data between PC and FPGA device via its SERIAL port.
- MOTOR
DC motor is present and can be used as above to indicate the inputs applied and the output of a design. Its speed can be varied using Pulse Width Modulation (PWM) at a maximum frequency of 5khz.
|
